The so-called running-in period of the breaker refers to the break-in period of about 60 hours after the hydraulic breaker leaves the factory (also known as the run-in period). The breaker often has a run-in period, which is also the technical feature of the early application of the hydraulic breaker based on the production plant. The emergence of the specified running-in period is to reduce the failure rate, and the standard use of the breaker during the running-in period is an important part of extending the service life.
Hammer
Don't think that the breaker has a warranty period and just treat it casually, let the breaker work under load! In this special period, everyone must do this kind of operation skill well, which can not only improve the efficiency of your later application of the breaker, but also increase its life.
1. Configure experienced operators to operate and maintain according to the equipment manual.
2. Check carefully and take precautions to prevent problems before they happen. Regularly check the quality of hydraulic oil, lubricating oil, and coolant, and carefully check the tightness of the whole machine.
It is recommended that during the running-in period, each shift needs to add grease to the lubrication point (except for special requirements).
Strengthen 2 points to pass the running-in period safely. The completion of the running-in period does not mean that the maintenance inspection is completed. Pay attention to the replacement of oil in actual use.
However, according to the current situation of many people, some users of large-scale breakers do not pay special attention to the special technical standards required for the running-in period of new machines because of lack of basic application knowledge, so they need to use their own breakers for a long time. The time is in an overload state, which leads to the short service life and low efficiency of the breaker, and obstacles appear early, which seriously affects the entire project process.
