Breaking hammer manufacturers tell you how to correctly install and disassemble when using the breaking hammer. The breaking hammer is a more important special tool in the excavator. After being used on the excavator, it can be used for some ground or underground drainage pipes. And other aspects of crushing operations. The first thing to use this equipment is to install it on the excavator. At this time, we need to install it in the correct way to prevent problems.
Breaking Hammer Manufacturers
1. First of all, you need to move the excavator to a relatively flat open space without mud and dust debris on it, and then turn off the engine to relieve the pressure and gas.
2. There is a shut-off valve at the end of the boom, we should put this shut-off valve, we should turn the shut-off valve to off, so that the internal hydraulic oil can be prevented from seeping out.
3. After the hose plug on the boom is removed, a small amount of hydraulic oil inside can seep out and be connected to the container.
4. We should prevent the soil from seeping into the oil pipeline. After the hose can be blocked, the internal thread plug is replaced to block the pipeline, and then the iron wire is used to tie the high and low pressure pipes.
5. If we should remove the breaker, first remove the joint of the stick. If we want to put the breaker outdoors, we need to take protective measures.
The above is what the breaker manufacturer will explain to you next, about the correct installation and disassembly method of the breaker, now I will talk about it here for everyone, see you next time.
