As a very important operating tool, the breaker can be properly controlled to improve work efficiency and prolong the service life of the breaker. The precautions for the operation of the breaker mainly include the following:
1. Suspend work when the hose vibrates violently
Check whether the high-pressure and low-pressure hoses of the breaker vibrate too violently. If such a situation occurs, immediately contact the designated local office to obtain maintenance services. Check whether there is oil leakage at the hose joints. If there is oil leakage, re-tighten the joint.
2, Avoid excessive air strikes
If the stone is broken, the hammering should be stopped immediately. If the air strike continues, the bolt will loosen or break. When the breaking hammer has an improper penetration force or the steel drill is used as a pry bar, the air strike phenomenon will occur.
3. Steel brazing can not be used as a pry bar
If the steel drill is used as a pry bar when crushing stones, the bolts and steel drill may break.
4, keep tapping for no more than 1 minute
When striking hard rocks, the same place should be struck continuously for no more than 1 minute, and then another place should be replaced. Long-term percussion operation will cause the oil temperature to rise, which will also cause damage to the brazing bushing and the brazing. Progressive wear.
5, Do not use the breaker to suspend objects
Do not tie the rope to hang the object on the breaker, as it is easy to damage the breaker, and such an operation is also dangerous.
The above content includes the precautions for the operation of the breaker introduced by the editor. I think everyone has already understood it. I believe that after understanding these product knowledge in detail, you can operate and use the product more reasonably and effectively. .