1. When there is obvious vibration, the actual operation should be suspended
It should be checked whether the high-voltage and low-voltage steel wire hoses of the silent breaker vibrate too much. If there is such a situation, it may be a common fault, and you should immediately contact your local service center approved by everyone for after-sales maintenance Service. The hose joint should be further checked for oil leakage. If there is oil leakage, the joint should be tightened again.
2, Suspend the actual operation (avoid excessive air strikes)
If the stone is broken, the hammering should be stopped immediately. If the hammer is continuously empty, the screw will be loose or broken, and even the excavator and the loading machine will be not well affected. When the breaker penetrates improperly or When the drill is used as a pry bar, it will cause the problem of empty strike. (The sound of the hammer will change when the hammer is empty strike)
3, can not be used to transport stones
Do not use the drill bit or the side of the support frame to roll or promote the stones. Because the steam pressure comes from the excavator, the big arm, the small arm, the bucket, the swing or the rolling application at this time, the size arm will be damaged, In addition, the mute breaker screw is very likely to be broken, the support frame will be damaged, and the drill will be broken or scratched. Avoid using the breaker to transport stones. In particular, it is pointed out that the drill is inserted in the stone, and the excavation will not work. able to move.
silent breaker
4. Do not use the drill as a pry bar
If the drill is used as a pry bar when crushing stones, the screws and the drill are very likely to be broken.
5. Continuous beating cannot exceed 1min
When hitting a solid rock formation, the same hitting continuity should not exceed 1min, and then change the actual operation of hitting. Long-term hitting application will cause high violations, which will cause damage to the drill bushing and drill progress.
6. For long, firm stones, it can be destroyed at the cracks or at the ends, so that it is relatively easier to break the stones.
7, should be operated at the basic car engine rotation rate
For the destruction of the breaker, the rotation rate of the car engine should comply with the specified time constant, and the rotation rate of the car engine exceeding the actual operation violation will not increase the striking force, but it will cause the violation of high and cause mechanical equipment damage.
8, can not be operated in water and mortar
Do not use a silent breaker in water or mortar, otherwise the piston rod or the like may rust and cause damage. If you violate the regulations in water or underwater engineering, you should especially choose an underwater breaker.
