Although the hydraulic hammers and hydraulic heads on the excavators that people rent can carry a lot of force. However, if they are used incorrectly, they will destroy the hydraulic hammer. This is why all operators must follow the best possible operating practices to increase the use of the equipment. the term.
hydraulic breakerCommonly adopted incorrectly below.
1. No need to use a compatible circuit breaker
If the hammer head is too large for the excavator, both the hammer head and the excavator can cause significant damage. Therefore, the size\/weight of the hammer head must always be matched to the lift capacity of the excavator.
2. Not using reasonable settings
The operator must also set up the circuit breaker and bracket for the specific application. For example, you may have to use the circuit breaker when the circuit breaker is partially or fully immersed in water. In this case, are you running an underwater kit on the system? Water Under the job must be underwater kit and air compressor.
3. Put the hammer in the wrong place
The operator must understand where the breaker should be placed to minimize stress on the fittings. A common practice is to place the hammer at the core of a boulder or concrete. In this location, the hammer acts like a drill, not a Hammer head. A reasonable approach is to gradually move the foot of the wall inward.
4. Don't have to use a "score" approach
When using circuit breakers, use what some people call "scoring". Essentially, this means that every time a chunk is split, it needs to be moved from one part to another. Designed to be used every time 15 to 30 seconds to reposition special tools.